Search the Community

These pegs come in pairs, fully assembled with the tread you select. All treads are silver anodized. Additional treads are available at the bottom of the page. Ready to buy? Select your parts below. Click on a photo for a larger view. Photos represent tread and finish you will receive. Mounting features (such as hole size) will be correct for your bike, which may not be exactly as shown in photos. All our foot pegs come in pairs. General Information Our motorcycle foot pegs are all have one piece mounts - a strong, simple design. They come in two categories; pegs for street bikes, with a tread 1-1/8 inches across by 3-3/4 inches long (29 mm x 95 mm), and pegs for dual-sport and off road bikes, with a tread 2 inches across by 3-3/8 inches long (51 mm x 86 mm). The wide pegs have the extra tread toward the back of the bike. We make each foot peg from solid 6061-T6 aluminum (heat treated, high strength alloy, sometimes called aircraft grade aluminum). Because these parts are aluminum, they will never rust. We sell all our foot pegs in pairs. Foot Peg Height and Lowered Foot Pegs We make foot pegs that come straight out of the mount, as well as models that lower your foot up to two inches or more. When you lower your foot position, you will want to check the height of your shift and brake levers for comfort and access, and adjust if needed. Tread We offer two tread options for street bikes, and two for dual-sport and off road models. They're shown at right. Click on the pictures for a larger view. Street Sidetrax is a good street bike tread, with grip most similar to your stock foot pegs. Quadtrax is a high traction tread, with small points on the top that grab onto your boot. Dual Sport and Off Road 2x3 Wide foot pegs have an interchangeable tread. They come with two tread options, both suited to dual sport and off road use: Hunter tread has the same traction points on the top as Quadtrax, but the foot peg is wider front to back, and shorter across your foot, giving a better base for your feet in rough terrain. Trakker tread has pin grips for your foot, and is good for use in the dirt and mud; the pins stick up further than with the other treads, reaching through dirt to give you a good grip. Safety All our foot pegs swing back like your stock pegs - important in case your peg gets close to the ground or another object. Ground Clearance For most bikes, the bottom tip of 1 inch lowered foot pegs sits at approximately the height and location of the tip of your stock curb feeler (the finger sticking out the bottom tip of your stock pegs). In this case, there is no loss of ground clearance with our lowered pegs. This varies widely from bike to bike; please ride with caution until you get used to your new foot pegs. Mounting Most of our pegs mount with your stock foot peg pivot pin, spring, and retaining clip. Exceptions are listed for specific models. Installation is quick and easy: remove your stock pivot pin retaining clip, pivot pin, and spring, noting orientation of the spring. Remove your stock foot peg and replace with our foot peg. Reinstall your spring, pivot pin, and retaining clip.