Neutrino PDM by Arboreal Systems


Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • By Eric Hall
      I like how Rich mounted these new Clearwater lights on his GSA

      I like them better there than lower where they get crunched in a tip over.  I also like their "can opener" that lets you tap into the can bus as well as take advantage of the existing handle controls/light switch/horn switch.
      They are a bit pricier too than my Rigid D2's but they are pretty cool
    • By Eric Hall
      Chris asked:
      Has anyone installed a Rowe Electronics PDM60? It's a self-contained power distribution module that is similar to a Fuze Block, but it has internal circuits (no fuses, just restart if circuit overloads) and a viewable panel that immediately shows circuit health. Would love to hear from you. I purchased one and am putting together a "clean" circuit strategy for my electronics (powerlet heated gear, ipod charging, phone, etc), so I'm sort of biding my time while I plan it out. Any comments about this would be appreciated.
    • By Off Road Rider
        Often one is faced with marketing propaganda that is tough to decipher. One area that there is often confusion or misunderstandings about is lumen ratings on Aftermarket LED Auxiliary lights.
      A lumen rating is the amount of light given off by any particular source, If we are talking about a light bulb, that is a legitimate use for a lumen rating, If we are talking about a complete light with optics, then the term lumen falls very much short of telling the customer any real info.
      Very often in today's market place, we see lights rated at 4400 lumens or even more.Will a 4400 lumen light allow you to see better than a 1000 Lumen light?
      Not necessarily, In fact sometimes quite the opposite, the 1000 lumen light wins. Optics are the key to getting a great quality light beam that will allow a rider to see what they need to, without blinding oncoming drivers and lighting up the tree tops. The real information that a rider needs is a lux rating at a given point, beam pattern selections are also very important.
      Prior to making a lighting decision for your trusty stead, take a look at what lights truly do offer a real optical enhancement that optimizes what lumens are available. In general a single source LED with a large optic will optimize the amount of Raw lumens at hand.  A multi-emitter light may look brighter, but do to the lack of space for quality optics they often can not match the long distance penetration offered by a single emitter design.
      Here is a great example of a quality built light that draws 10 watts of power yet provides more than 800 ft of light throw, 
      The Cyclops Adventure sports Long Range Optimus LED offers Outstanding long range distance as well as a tunable product with the availability of wide beam filters that alter the beam pattern for a Clipped optic (upper Cuttoff) that helps to eliminate oncoming blindness, yet retains much of the long Range Penetration so commonly not found on LED aux lights.
      Note the large optic and single emitter design.
      With the wide angle filter
      LED lighting is a continuously evolving technology, we will all be rewarded with great products from top manufactures and suppliers as time goes on. In this case a little knowledge goes a long ways.
      Darryl VanNiewenhuise
      Cyclops Adventure Sports

      This post has been promoted to an article
    • By Nate J.
      I have a goal to install a PDM60 on my Super Tenere to control some lighting and accessories. Of course I want to control some of those outputs with some accessory switches. My vision is to find a handlebar mounted switch cluster containing 3 or 4 accessory switches that I can wire to the PDM60 to facilitate further control of the outputs. I've searched and searched, and all I can really find are some chrome, brake/clutch reservoir mounted switch packs that really don't fit the genre, or single switches. Does anybody know of anything that might fit the bill for what I'm trying to do?
      Thanks in advance!